Wirebench
AWG, ft, °Fmm², m, °C

Electrical engineering and NEC code safety disclaimer

Mandatory safety notice regarding informational estimates, licensed engineering review, and local Authority Having Jurisdiction (AHJ) code enforcement.

1. Informational estimates only

Verify before installation

All calculators, reference tables, worked examples, and materials take-offs on Wirebench Pro (https://wirebenchpro.com) are provided strictly as informational and educational estimates. While our calculation engine (assets/nec-core.js) models formulas and lookup values from the National Electrical Code (NFPA 70, 2023 and 2026 editions) and IEC 60228, real-world electrical installations involve site-specific variables that no web calculator can fully observe.

2. Not a substitute for a licensed electrician or Professional Engineer (PE)

Nothing on this website constitutes licensed professional engineering advice, electrical contracting advice, or code inspection approval. Improperly sized conductors, raceways, grounding paths, or overcurrent protective devices (OCPDs) can cause catastrophic equipment damage, insulation failure, electrical fires, arc flash, severe injury, or death.

Always engage a qualified, licensed electrician or a registered Professional Engineer (PE) to design, verify, install, and inspect any electrical circuit, feeder, service entrance, or equipment connection.

3. Local Authority Having Jurisdiction (AHJ) amendments take precedence

Under NEC 90.4, the local Authority Having Jurisdiction (AHJ)—such as your municipal building department, state electrical board, or electric utility—has the sole authority to interpret code rules, approve equipment, and enforce local amendments:

  • Adopted code cycle differences: States and municipalities adopt different editions of NFPA 70 (for example, 2017, 2020, 2023, or 2026 NEC). Thresholds for GFCI/AFCI protection, service load demand factors, and outdoor disconnects vary across editions.
  • Local municipal and utility amendments: Many jurisdictions restrict aluminum conductors on branch circuits, mandate metallic raceways (EMT/RMC), enforce stricter voltage drop limits for energy-code compliance, or require larger service-entrance conductors than the NEC baseline.
  • Equipment nameplate instructions (NEC 110.3(B)): Listed and labeled equipment must always be installed and wired in accordance with the manufacturer's instructions and nameplate ratings, which may specify copper-only terminals, 60 °C lug limits, or specific maximum fuse sizes.

4. Mandatory pre-installation verification checklist

Before purchasing materials or energizing any circuit, you must independently verify every selection against the official codebook and site conditions:

  1. Confirm the exact continuous and non-continuous load currents, duty cycle, and system voltage/phase configuration.
  2. Verify conductor insulation temperature rating (60 °C, 75 °C, or 90 °C) and equipment terminal temperature rating per NEC 110.14(C).
  3. Check worst-case ambient temperature (rooftop, attic, underground duct, or industrial truss) and total current-carrying conductors in each raceway per NEC 310.15(B) and (C).
  4. Verify overcurrent protective device (OCPD) ampacity, small-conductor limits per NEC 240.4(D), next-size-up eligibility per NEC 240.4(B), and available fault-current interrupting rating (AIC/SCCR) per NEC 110.9.
  5. Confirm equipment grounding conductor (EGC) sizing and proportional circular-mil upsizing per NEC 250.122(B) whenever phase conductors are upsized for voltage drop.